Suitable for INTERIOR & EXTERIOR use. Effective for removing oil, grease, ingrained dirt, grime and old wax layers. Suitable for use on travertine, limestone, terracotta, quarry tiles, granite, slate, sandstone, marble, concrete, brick, external paving, grouting and glazed ceramic wall and floor tiles.

Recommended For Use With:

• Travertine
• Natural Stone
• Sandstone
• Slate
• Marble
• Granite
• Terracotta
• Stone  
• Brick
• Concrete
• External Paving
• Glazed Ceramics
• Grouting

Coverage: From 10 - 50 sq m dependent upon concentration

Pure Adhesion Product Selector

Instructions:
Important: - Test the solution on an inconspicuous area before general application.  Any alkalinity remaining on surfaces treated with this product should be completely neutralised.  This may be done with a little clean water applied by sponge.

Directions:
In mild cases and on absorbent tiles: Dilute 1 part cleaner in 10 parts warm water.  Apply with a cloth or mop.  Wipe off thoroughly with a clean damp cloth.

In more severe cases: Dilute 1 part cleaner in 3 parts warm water.  Apply liberally, spreading over surface of tiles.  If necessary agitate with a scrubbing brush.  leave to react for 5-10 minutes, keeping wet with additional cleaning solution.  Mop up and rinse thoroughly with clean water.

Coverage:
In mild cases   - approximately 50m2
In more severe cases  - approximately 20m2  
In extremely severe cases  - approximately 5-10m2

Attention:
Keep out of reach of children
Use gloves to apply
Avoid contact with eyes and skin
In case of contact with eyes rinse with plenty of water and seek medical advice
In case of swallowing seek medical advice.

This product should not be used for every day cleaning of sealed floors.

This information is offered without guarantee. The material should be used so as to take account of the local conditions and the surfaces to be treated.  In case of doubt, the product should be tried out in an inconspicuous area.